RV-5 Receiver 7.1


RV-5

Logic 7 receiver.


Brochure PDF

 
Performance (Composite & S-Video)
Differntial Gain < 0.2%
Differential Phase <0.5°
Gain ±0.15dB
Signal-to-Noise Ratio >65dB
Frequency Response Composite: 10Hz to 8MHz, -3dB
Compatibility NTSC, PAL and SECAM
A/D Converter 12-bit, 110MHz
D/A Converter 12-bit, 74.25MHz
Input Level/Impedance 1V peak-to-peak/75O
Output Level/Impedance 1V peak-to-peak/75O
 
Performance (Component Video)
Impedance 75O
Bandwidth >100MHz
Insertion Loss <3dB
Compatibility 3-channel (Y, Pr, Pb), format-independent
Frequency Response 10Hz to 100MHz, -3dB
 
Performance (FM Tuner)
Tuning Range 87.5MHz to 108MHz
Selectivity ± 400kHz, 70dB
Signal-to-Noise Ratio Mono: 70dB, stereo: 65dB
Image Rejection 43dB
Sensitivity IHF 8 uV/19.2dBF
IF Rejection 75dB
Stereo Separation 51dB at 1kHz
Distortion Mono: 0.2%, stereo: 0.1%
 
Performance (AM Tuner)
Tuning Range 520kHz to 1720kHz
Selectivity Loop 177uV/m
Signal-to-Noise Ratio ± 10kHz, 25dB
Image Rejection 45dB
Sensitivity 32dB
IF Rejection 40dB
Distortion 1.2%
 
HDMI Performance
HDMI Input Video: 480i/p, 576i/p, 720p or 1080i
Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)
HDMI Output Video: 480i/p, 576i/p, 720p or 1080i
Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)
 
Inputs
Analog Video Three component video, RCA connectors
Four S-Video connectors
Four composite video, RCA connectors
Digital Audio Four S/PDIF coaxial (RCA) and four S/PDIF optical (Toslink) connectors. Coaxial and optical input connectors conform to IEC-958, S/PDIF standards
One USB mini-B connector
Analog Audio One 8-channel input array, RCA connectors
siz stereo RCA connectors
One microphone, 3.5mm mono mini plug
1 dock 30-pin connector (for optional docking station)
1 FM antenna
1 AM antenna
Input sensitivity = max input level 2Vrms
Control One RS-232, 9-pin, D-sub connector
One IR receiver, on front panel
One 3.5mm IR in jack, input voltage: 3V - 15V, input current: 10mA, Frequency: 20Hz - 1kHz. Accepts either stereo plug (tip/ring/sleeve) or mono plug (tip/sleeve)
 
Outputs
HDMI (Version 1.1) One HDMI type A, 19-pin connector
Analog Video One component video, RCA connector
One S-Video connector
One composite video, RCA connector
Analog Audio 7-channel amplified, binding posts
One 8-channel preamplifier plus additional subwoofer, RCA connectors
Control Two triggers - one power on/off and one programmable. 3.5mm mono mini plugs, 12VDC, 300mA maximum output draw
 
General
Power Requirements 120V, 60Hz, 1300W, IEX detachable power cord (supplied)
230V, 50Hz, 1300W, IEC detachable power cord (supplied for EU and UK)
Power Consumption 4.82W at power on, idle 1235W at rated power output (7 channels driven)
Dimensions Height (with feet): 6.6 inches (168mm)
Height (without feet): 6 inches (153mm)
Width: 17.3 inches (440mm)
Depth: 15.6 inches (397mm) (includes knobs, buttons and terminals)
Weight Net weight: 39.7lb (18kg)
Gross weight: 55.1lb (25kg)
Rack Mounting Lexicon built rack mount kit not available. Please seek alternative
Operating Environment Operating temperature: 0 to 45°C (32 to 113°F)
Storage temperature: -20 to 60°C (-4 to 140°F)
Relative humidity: 93% max without condensation
Remote Control Hand-held, back-lit, IR/RF (FR for use with optional RF-1 receiver) pre-programmed and learning remote control (requires 4 AAA batteries - included)
 
Amplifier Outputs
Continuous Output Power 85W per channel, 8O, all channels driven, 20Hz to 20kHz
Frequency Response 10Hz to 40kHz, +0, -2dB
THD + Noise <0.05%, 20Hz to 20kHz, 1W, <0.07%, 20Hz to 20kHz, 85W
IM Distortion <0.04%
Slew Rate 17V/us (condition: output 40Vpp, 1k sine wave, rising time from 10% to 90%)
Signal-to-Noise Ratio 95dB typical, 22kHz bandwidth, min 95dBA, 90dBA typical
 
Preamplifier Outputs
Frequency Response 10Hz to 40kHz, +0, -2dB
THD + Noise <0.05%, 20Hz to 20kHz
Dynamic Range 100dB typical, 22kHz bandwidth
Signal-to-Noise Ratio 100dB typical, 22kHz banwidth, min 100dBA, 103dBA typical
Output Level 200mV typical, 5V maximum
 
QR-Code