MV-5 Vorstufe 7.1


in CHF
inkl. MwSt.
Surround Decoder / preamp
Performance (Compsite & S-Video) :
Differential Gain <0.2%
Differential Phase <0.5°
Gain ± 0.15dB
Signal-to-Noise Ratio >65dB
Frequency Response Composite: 10Hz to 100MHz, -3dB
S-Video: 10Hz to 8MHz, -3dB
Compatibility NTSC, PAL and SECAM
A/D Converter 12-bit, 110MHz
D/A Converter 12-bit, 74.25MHz
Input Level/Impedance 1V peak-to-peak/75O
Output Level/Impedance 1V peak-to-peak/75O
Peformance (Component Video):
Impedance 75O
Bandwidth >100MHz
Insertion Loss <3dB
Compatibility 3-channel (Y, Pr, Pb) format-independent
Frequency Response 10Hz to 100MHz, -3dB
HDMI Performance:
HDMI Input Video: 480i/p, 576i/p, 720p or 1080i
Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)
HDMI Output Video: 480i/p, 576i/p, 720p or 1080i
Audio: Dolby Digital, DTS and PCM (32, 44.1, 48, 88.2, 96, 176.4 and 192kHz)
HDMI (Version 1.1) 2 HDMI Type A, 19-pin connectors
Analog Video Three component video, RCA connectors
Four S-Video connectors
Four composite video, RCA connectors
Digital Audio Four S/PDIF coaxial (RCA) and four S/PDIF optical (Toslink) connectors (coaxial and optical input connectors conform to IEC-956, S/PDIF standards)
One USB mini-B connector
Analog Audio One 8-channel input array, RCA connectors
Six stereo RCA connectors
One microphone, 3.5mm mono mini plug
1 dock 30-pin connector (for optional docking station)
Control One RS-232, 9-pin, D-sub connector
One IR receiver, on front panel
One 3.5mm IR in jack - input voltage: 3v - 15 , input current: 10mA, frequency: 20Hz - 1kHz, accepts either stereo plug (tip/ring/sleeve) or mono plug
HDMI (Version 1.1)

One HDMI Type A, 19-pin connector

Analog Video

One component video, RCA connector
One S-Video connector
One composite video, RCA connector

Analog Audio One 8-channel pre-amplifier plus additional subwoofer, RCA connectors
Zone 2 analog out, 1 RCA stereo connector
Control Two triggers - one power on/off and one programmable, 3.5mm mono mini plugs, 12VDC, 300mA maximum output draw
Performance (Main Zone and Zone 2 :
A/D Conversion 24-bit, 96kHz, dual-bit
D/A Conversion 24-bit, 44.1 to 192kHz, multi-bit
Input Sensitivity 200mV for analog 1 to 6, and 200mV for 8-ch input
Max input level: 2Vrms
Input Impedance 98.5kO for analog 1 to 6, and 32kO for 8-ch input
Frequency Response 10Hz to 40kHz, +0, -2dB
THD + Noise <0.05%, 20Hz to 20kHz
Dynamic Range 100dB typical, 22kHz bandwidth
Signal-to-Noise Ratio 100dB typical, 200kHz bandwidth, min 100dBA, 103dBA typical
Output Level 200mV typical, 6Vrms maximum
Output Impedance 570O
Power Requirements 90-250VAC, 50-60Hz, 50W (universal line input), IEC detachable power cords (supplied)
Power Consumption 3.76W at power on, idle, 47.2W at rated power output (HDMI in/out mode)
Dimensions Height (with feet): 5.0 inches (127mm)
Height (without feet): 4.3 inches (109mm)
Width: 16.8 inches (426mm)
Depth: 16.7 inches (423mm) (includes knobs, buttons and terminals)
Weight Net weight: 17.6lb (8kg)
Gross weight: 26.5lb (12kg)
Rack Mounting Lexicon built rack mount kit not available. Please seek alternative
Operating Environment Operating temperature: 0 to 45°C (32 to 113°F)
Storage temperature: -20 to 60°C (-4 to 140°F)
Relative humidity: 93% max without condensation
Remote Control Hand-held, back-lit, IR/RF (RF for use with optional RF-1 receiver) pre-programmed and learning remote control (requires 4 AAA batteries - included)